Kategória: Lakás, otthon, kert, barkács
Honlap:
Részletek... Appliance disconnector as protection against deep battery discharge. Maximum load current 100 A. Integrated Bluetooth for easy setup. Battery protection Smart BatteryProtect protects the battery from excessive discharge (which could damage the battery) and can be used as an on / off system switch. Automatic setting 12 / 24V BatteryProtect battery protection automatically detects system voltage. Integrated Bluetooth = very easy to program Thanks to the integrated Bluetooth function for Smart BatteryProtect programming, the required voltage levels for connecting / disconnecting the load can be easily set. You can make settings via smartphone, tablet or PC using the VictronConnect app. Alternatively, one of the nine preset connection / disconnection levels can be set using the programming pin (see manual). Bluetooth can be turned off if needed. VictronConnect application Download the application for free under the name VictronConnect app in the App Store or Google Play. The application can be downloaded from this Victron Energy software website: https://www.victronenergy.com/support-and-downloads/software#victronconnect-app Special settings for Li-ion batteries In this mode, Smart BatteryProtect protection can be controlled via the VE.Bus BMS bus. Note: Smart BatteryProtect can also be used as a charge disconnector between a battery charger and a Li-ion battery. See the wiring diagram in the manual. Very low energy consumption Low power consumption is very important for Li-ion batteries, especially after switching off at low voltage. For more information, please see the Li-ion battery datasheet and VE.Bus BMS manual. Overvoltage protection In the event of an overvoltage resulting in possible damage to sensitive devices, the devices are disconnected if the DC voltage exceeds 16 V or 32 V. Resistant to sparks It does not work with relay elements but with MOSFET transistor switches, no sparking occurs. Delayed alarm output The alarm output is activated if the battery voltage drops below the set value for more than 12 seconds. Starting the engine therefore does not activate the alarm. The alarm output is an open collector output to negative bus, max. current 500 mA. The alarm output is typically connected to a buzzer or traffic light. Delayed load disconnection The load is disconnected 90 seconds after the alarm is triggered. If the battery voltage rises to this level during this time Connection thresholds (eg during motor starting), the load will not be disconnected. The load reconnects 30 seconds after the battery voltage rises to more than the preset reconnect voltage. BatteryProtect battery protection is one-way, ie. current can only flow from the in input to the out output. Reverse current flowing from the out output to the in input is not permitted and will damage the device.
